PRODUCT  »​  ANCHOR  »​  GRIP ANCHOR

GA-TYPE  
SANKO GRIP ANCHOR (GA-TYPE)​​  
 
DESCRIPTION  
 
SPECIAL FEATURES  
  1. This anchor will work with a bolt or threaded rod in any length.
  2. Drill holes same length as anchor for flush finish or deeper for more embedment into concrete.
  3. Place the special setting tool on the top of anchor then strike until the anchor flushes with concrete and the strong hitting reflection is perceived.
  4. If anchor is no longer needed, can fill with cement to make the surface smooth again.
  5. The anchor is set (fully expanded) when the shoulder of the setting tool seats on the top of anchor.
  

INSTALLATION METHOD		  
 
 

INSTALLATION INSTRUCTION		  
  1. Drilling hole with recommended diameter and depth.
  2. Cleaning hole.
  3. Usring setting tool to drive anchor body until flushed with concrete surface.
  4. Put fixture in place and tighten bolt.
  

HOW TO INSTALL AND USE SANKO GRIP ANCHOR		  

 

TECHNICAL FEATURES		  
 
 

APPLICATIONS		  
 
SANKO GRIP ANCHOR Hanging insulated boiler pipe, Piping system, Blower, Heater, Conduit, And etc.  



 

CONTACT US

2 Soi Phaholyothin 96, Prachatipat, Thanyaburi
Pathumthani, 12130, Thailand
TEL : +66(0) 2516-9823-5
FAX : +66(0) 2516-9385, +66(0) 2516-9826
E-MAIL : trading@sanko.co.th
WEBSITE : www.sanko.co.th
SANKO TECHNO : www.sanko-techno.co.jp
       

DOWNLOAD

CAREERS

ABOUT US

PRODUCT