No.1 FLUSH MOUNTED FIXING WITH INTERNAL MALE THREAD

No.2 PRE-ASSEMBLED PLUG/TAPERED INSERT PIN

No.3 SMALLER HOLE SIZE THAN MOST OTHER FLUSH MOUNTED TYPE

1. Drop-in anchor will work with bolts or threaded rods of any length.
2. Drill holes same length as anchor for flush finish or deeper for more embedment into concrete.
3. If anchor is no longer needed, can fill with cement to make the surface smooth again.

No.1 FLUSH MOUNTED FIXING WITH INTERNAL MALE THREAD

No.2 PRE-ASSEMBLED PLUG/TAPERED INSERT PIN

No.3 SMALLER HOLE SIZE THAN MOST OTHER FLUSH MOUNTED TYPE

1.This anchor will work with bolts or threaded rod in any length.

2. Drill holes same length as anchor for flush finish or drill deeper for more embedment into concrete.

3. The short body and expansion flange allow this type of anchor to be installed in shallow embedment or bottomless holes.

The anchor is set (fully expanded) when the shoulder of the setting tool touches the anchor.

Application :  

• Hanging insulated boiler pipe
• Piping system
• Blower
• Heater
• Conduit
• And etc

Application :

1.Drill hole proper diameter.

2. Clean hole and insert anchor eith plug inside.

3. Insert anchor use setting tool and hammer to drive tapered insert.

4. Anchor is set and ready to accept any bolt.

คลิกดาวน์โหลดที่ลิงค์ด้านล่าง

http://www.sanko.co.th/Download/GT-Type.pdf